This device may not cause interference.Operation is subject to the following two conditions: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). this device must accept any interference received, including interference that may cause undesired operation.this device may not cause harmful interference, and.This device complies with Part 15 of the FCC Rules. Consult the dealer or an experienced radio/TV technician for helpĬhanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Increase the separation between the equipment and receiver.Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. (10m)įM Transmitter Frequency Range: 88.1407.9M Hz (200 KHz steps) SPECIFICATIONSīluetooth v5.0, Class II, up to 33 ft. Simply connect using a cable suitable for your device (not included). Your BTFREQ PRO includes (1) USB-C port and (1) USB-A port to charge your devices while driving. Press and hold the Multi-function button for 3 seconds to activate your smartphone’s voice assistant. Press MFB once to answer the call Press MFB once to end the call Press and hold MFB to reject the call SECTION H Receiving a Call Phone call will come in through the BTFREQ PRO. Note: Press “CH” button to change frequencies on BTFREQ PRO (1). Repeat the above steps to find a different clear station. If you experience interference you may have entered an area where there is an active broadcast signal on the station you are tuned to. Press the “CH” button (1), then turn the tuning lever up (2) or down (3) to tune the BTFREQ PRO to match the frequency of your FM radio. SECTION CĬonnecting to your Car’s Stereo F ind a weak station on your FM radio that has no active broadcast signal. Once connected, ensure your device is set to maximum volume. Your phone will confirm once it is connected.From the list of available accessories, find and select the “Scosche BTFMPD3”. Enter the Bluetooth settings in your mobile device and enable the Bluetooth function.Plug the BTFREQ PRO into your car’s 12V power socket.SECTION H – Voice Assistant Activation & Dual-Port USB Charger SECTION Aġ.SECTION D – Reconnect to your Device & 3.5mm AUX OUT Connection.SECTION C – Connecting to your Car’s Stereo.SECTION B – Power Up & Bluetooth Pairing.11.1 Related Manuals / Resources DEVICE SETUP
0 Comments
Leave a Reply. |